Unibox

Home

UNIBOX protection boxes are designed as two-part construction horizontal parting line between the upper and the lower part. This type of construction allows for maximum accessibility during installation or maintenance of differential pressure transmitters and the associated manifolds. The removable or hinged lid allows cable entries from the front, rear, sides or bottom. .

Impulse line can enter through a flat lower part into horizontally split UNIBOX from all sides. With the lid open, you have perfect access to the transmitter.

Made of hot-pressed glassfibre reinforced polyester (GRP).
Two-part construction

The boxes are fire-proof with self-extinguishing properties.

Colour : Light grey ( RAL 7032 ), UV resistant

Ingress protection : IP 65 / NEMA 4X ( higher degree of protection upon request )

Variants
SV	2 clasps stainless steel
SE	2 hinges, 2 clasps stainless steel, can be mounted on a long or short side
DF	lid propstay, galvanized steel, mounted
DFVA	lid propstay, stainless steel, mounted
DFGF	lid propstay, gas compression spring (upon request)
FA..	Acrylic glass window
FS..	safety glass window
arctic-Alu	PU-foam insulation encapsulated between two layers of GRP
GO	reduced surface resistance 10⁹ Ohm acc. to EN 60079 ( grey RAL 7001 colour)
(Ex)p	ready for overpressure protection according to EN 60079-2

Accessories

All necessary mounting accessories: mounting rails, 2" pipe stand, etc. see the relevant catalogue sheets - 19" frame, fixed or swivel.
Heating: Ex., electric, steam or hot water.

Mounting orientation